You can fix this
Likely cause: a loose set screw or retainer
A wobbly single handle that still controls the water needs its set screw seated on the stem's flat side, and sometimes the retainer ring under the cap snugged.
Why this happens
Most single-handle faucets hold the lever on with one small set screw. Delta's answer for a handle that keeps coming loose is to line the set screw up with the flat part of the valve stem when you put the handle back. Pfister says a handle that is really loose, or that turns the water off by itself, also points at the plastic retainer ring under the dome cap. The common mistake is cranking the screw harder: American Standard warns that overtightening can strip the screw.
How to fix it
- Close both stops under the sink, then lift the handle to on to make sure no water comes out. Pfister and American Standard both start with the water off at the stops, and Moen says opening the handle confirms the water is off.
- Close the drain. Then lay a towel in the sink, as American Standard suggests, so the tiny screw cannot disappear.
- Find the set screw. Pfister says it is usually right under the handle, sometimes behind a plug you pop off with a small flat screwdriver. Pfister and Kohler both call for a 3/32 in. hex key, and Kohler also lists 2.5 mm.
- Kohler's order for its Mazz faucet: turn the water off at the stops, swing the handle to the on position, then turn the set screw clockwise until the handle sits firmly.
- If it works loose again, take the handle off and find the flat side of the stem. Delta says to line the set screw up with that flat before you tighten.
- Still wobbly: Pfister says unthread the dome cap and turn the retainer ring clockwise with an adjustable wrench on its flats until tight. Slide the handle on and test it before you refit the cap.
- On Moen faucets that use a handle connector, Moen says a broken connector or a missing gray metal washer can let the faucet close the water by itself. Replace the connector, and move that washer to any new cartridge.
When to stop. If a stop under the sink will not close by hand, or it drips when you move it, leave it alone and call a plumber; never force a stuck stop. If the set screw turns without tightening or its hex is rounded out, stop and get the replacement screw or handle connector for your model; American Standard warns that overtightening can strip the screw.
If this does not fix it, tell the plumber
- It is a single-handle faucet whose handle wobbles but still controls the water.
- Whether you tightened the set screw on the stem's flat side and the retainer ring.
- The brand, and whether the set screw hex is rounded out.
Build the full list: what to tell the plumber.
Not quite what you are seeing? Other results in this troubleshooter: Call a plumber: the shutoff won't close; a broken cartridge or connector; a loose handle screw; a stripped handle or stem tip; a missing or flipped stem stop; a broken stem on that side; a stripped spigot handle or stem.
Start this troubleshooter over
- Delta: The handle on my kitchen faucet keeps coming loose
- Pfister: My kitchen handle is not working properly
- American Standard: Fixing a single-handle faucet handle that came off
- Kohler: Loose handle (Mazz kitchen faucet)
- Moen: Handle will not stay in the on position (one-handle faucets)
- Moen: How to turn off the water supply to the faucet
FourHome is our sister brand. Browse all FourHome replacement faucet and shower parts on the FourHome Amazon store. We earn from purchases made through this link.