Vent, Valve & Volt
Faucet handle loose, wobbly or spinning all the way around

You can fix this

Likely cause: a missing or flipped stem stop

If the handle still controls the water but swings past off or on, the stop that limits its travel is missing, turned the wrong way, or broken.

Why this happens

Quarter-turn stems carry a stop that sets where the handle starts and ends. Delta says the stem must go back with the stop toward the spout on knob handles and toward the right on lever handles, and that lever-handle faucets may also need their quarter-turn stops reinstalled to keep the handles from turning more than 90 degrees. If the faucet was worked on before, suspect a stem put back the wrong way or a stop piece left out.

How to fix it

  1. Close the stop for that side, open the faucet to release pressure, and close the drain.
  2. Remove the handle (pry off the button and remove the screw, or loosen the set screw), unscrew the bonnet nut and lift the stem straight out.
  3. Check that the stop piece is there and not cracked. Delta sells its RP25513 stem for faucets that need the quarter-turn stop.
  4. Delta: set the stem with its tabs in the body slots, stop toward the spout for knobs or to the right for levers, and put the quarter-turn stop back on lever handles. If the handle then turns the wrong way, rotate the stem 180 degrees.
  5. Moen widespread faucets with a D-shaped stem extension: Moen says lift the extension, turn it 180 degrees and reseat it. In a standard install the hot handle faces 9:00 and the cold handle 3:00. Test the rotation before you screw the handle down.
  6. Start the nut by hand. Moen warns against cross-threading it; finish with pliers only once it runs on smoothly.

When to stop. If the stop for that side will not close by hand, or it drips when you move it, leave it alone and call a plumber; never force a stuck stop. If the stem will not seat with its tabs in the body slots, or the nut will not start by hand, stop; a cross-threaded nut on the faucet body is a plumber's repair.

The part that fixes it

Delta's RP25513 is the version with the quarter-turn stop. Other brands build the stop into the stem, so match the stem to your faucet.

Replacement for Delta RP1740 Two-Handle Stem Repair Kit

FourHome is our sister brand. We earn from purchases made through this link.

Replacement Two-Handle Ceramic Disc Stem for Delta, Glacier Bay and Luxtra

FourHome is our sister brand. We earn from purchases made through this link.

Not sure which part you have? Pull the old one and match it by brand, length and broach on Stems & Cartridges, an identification index of faucet stems and cartridges by part number.

If this does not fix it, tell the plumber

  • It is a two-handle faucet whose handle turns past off or on but still controls the water.
  • Whether the stem had a stop piece and which way it faced.
  • The faucet brand, and whether the stem was replaced before.

Build the full list: what to tell the plumber.

Not quite what you are seeing? Other results in this troubleshooter: Call a plumber: the shutoff won't close; a loose set screw or retainer; a broken cartridge or connector; a loose handle screw; a stripped handle or stem tip; a broken stem on that side; a stripped spigot handle or stem.

Start this troubleshooter over

FourHome is our sister brand. Browse all FourHome replacement faucet and shower parts on the FourHome Amazon store. We earn from purchases made through this link.