You can fix this
Likely cause: debris knocked loose into a screen
Shutting the water off and on, or cutting into a pipe, can shake loose grit that lodges in the faucet's aerator, inlet screens or cartridge. Clean the screens and flush the lines.
Why this happens
Kohler says that during a new faucet installation, turning the water supply on and off can kick free dirt or debris within the home's water lines, and that low flow can show up on the hot or cold side alone. That grit stops at the first fine screen it meets. Depending on the faucet, that is the aerator at the spout tip, small inlet screens in the supply connections under the sink, or the cartridge itself.
How to fix it
- First check the hot stop under the sink. Moen's starting point for low flow is making sure the shutoff valves under the sink have not been turned off. Turn it counterclockwise by hand until it stops; if it will not turn, do not force it, and call a plumber.
- Close the drain so small parts cannot fall in. Unscrew the aerator: Moen says one with threads on the outside unthreads clockwise, and one with threads inside unthreads counterclockwise. Rinse the screens.
- With the aerator off, run full hot and then full cold for at least 15 seconds each, as Pfister suggests, then reinstall the aerator hand tight.
- If hot is still weak, shut off both stops by turning them clockwise by hand, then open the faucet to relieve pressure. If a stop will not turn by hand, do not force it; call a plumber. Check the supply hoses for kinks, which Kohler also names.
- Some faucets have screens in the supply connections. Pfister puts them in the inlet lines on open-spout faucets; Moen puts in-line filters in the brass ends of the supply lines on some models. Remove them, rinse them, and put them back.
- Hold the disconnected hot supply securely, point it into a bucket, and open the hot stop by hand. Pfister suggests about 30 seconds to flush built-up debris. Then close the hot stop again by hand, as Pfister does, before you reconnect the line, reopen the stop and test.
- Pull-out kitchen faucet: Kohler's test is to remove the sprayhead and run water through the bare hose. Good flow from the hose means the sprayhead is clogged; soak it in half white vinegar and half warm water.
When to stop. If the hot supply still runs weak into the bucket with the stop fully open, the blockage is in the pipe or the stop, not the faucet. Stop there and call a plumber.
If this does not fix it, tell the plumber
- Hot went weak or cold at one faucet right after pipe work or a water shutoff.
- Which screens you cleaned and what you found in them.
- Whether flushing the hot supply into a bucket gave strong flow.
Build the full list: what to tell the plumber.
Not quite what you are seeing? Other results in this troubleshooter: Gas smell: leave the house now; the water heater, not this faucet; a frozen hot line; the hot stop is not fully open; the cartridge is turned backward; a stuck or clogged cartridge; a worn, broken or reversed hot stem; Call a plumber: the hot stop is stuck or leaking.
Start this troubleshooter over
FourHome is our sister brand. Browse all FourHome replacement faucet and shower parts on the FourHome Amazon store. We earn from purchases made through this link.