Vent, Valve & Volt
No hot water at one faucet, but hot everywhere else

You can fix this

Likely cause: the cartridge is turned backward

If the hot shows up when you swing to cold, the cartridge stem is rotated half a turn. On a Moen 1225 cartridge you fix that by turning the stem, with no new parts.

Why this happens

On a single-handle faucet, the cartridge stem decides which way is hot. Moen says the notch on the 1225 cartridge stem sets the hot and cold locations, and that hot and cold sometimes end up reversed after a new 1220 or 1225 cartridge goes in. Swinging to full cold and getting hot is the tell; nothing is broken.

How to fix it

  1. These steps are for Moen faucets with a 1220 or 1225 cartridge, the ones Moen's reversing guide covers. On any other faucet, do not twist the stem; follow that maker's instructions or call a plumber.
  2. Shut off both stops under the sink by turning them clockwise by hand. If there are no stops, Moen says the shutoff may be the main shutoff for the whole home. If a stop or the main will not turn by hand, do not force it; call a plumber. Then open the faucet to relieve pressure. Moen says any repair needs the supply off. Close the drain.
  3. Remove the handle so you can see the cartridge stem.
  4. Look under the sink. Moen says if the hot supply is on the left, the notch on the stem faces the front of the faucet; if the hot supply is on the right, the notch faces the back.
  5. Rotate the stem 180 degrees, half a turn, either direction. Moen says the cartridge does not need to come out.
  6. Reinstall the handle, reopen the stops slowly, and check that left is now hot.
  7. Moen faucets that use a 1255 or 4000 cartridge cannot be reversed this way. Moen says the only fix there is swapping the supply lines feeding the faucet.

When to stop. If the stem will not turn, or the copper retaining clip looks damaged, stop. Moen says the water cannot be turned back on until a damaged clip is replaced, so leave the stops off and call a plumber.

Identify the part first

Not sure which part you have? Pull the old one and match it by brand, length and broach on Stems & Cartridges, an identification index of faucet stems and cartridges by part number.

If this does not fix it, tell the plumber

  • A single-handle faucet gives hot on the cold side.
  • The faucet brand, and whether a new cartridge went in recently.
  • Whether turning the stem half a turn fixed it.

Build the full list: what to tell the plumber.

Not quite what you are seeing? Other results in this troubleshooter: Gas smell: leave the house now; the water heater, not this faucet; a frozen hot line; debris knocked loose into a screen; the hot stop is not fully open; a stuck or clogged cartridge; a worn, broken or reversed hot stem; Call a plumber: the hot stop is stuck or leaking.

Start this troubleshooter over

FourHome is our sister brand. Browse all FourHome replacement faucet and shower parts on the FourHome Amazon store. We earn from purchases made through this link.