Faucet squeals, whistles or chatters when it's on
A faucet that squeals, whistles or chatters is almost always water squeezing through a spot that is too narrow, and a loose or worn part shaking in the stream. Let's figure out where that spot is: the shutoff under the sink, the aerator, or a washer, stem or cartridge inside the faucet.
Also searched as: faucet squealing when turned on, faucet whistles when turned on, faucet makes noise when turned on, faucet whistles hot water.
Every question and answer on this page, in order
Question 1: What kind of noise is it, and when does it happen?
Turn the faucet on and off a few times at different speeds and listen.
- A bang or thump right as the faucet shuts off: Likely cause: water hammer, not the faucet
- A squeal, whistle, chatter or hum while water runs, or as I turn the handle: go to question 2
Question 2: Is it just this faucet, or other taps too?
Run another sink and the tub, first on full hot, then on full cold. This Old House says to note whether the noise is on hot, cold or both.
- Just this faucet: go to question 3
- Many faucets, or the pipes hum all over the house: Call a plumber: water pressure may be too high
- Every hot tap in the house, while cold is quiet: Call a plumber: every hot tap whistles
Question 3: Are both shutoff valves under the sink fully open?
Turn each one counterclockwise by hand until it stops. Never force a valve that will not turn.
- One was partly closed, and opening it quieted the faucet: Likely cause: a shutoff left partly closed
- Both are fully open and the noise is still there: go to question 4
- A valve is stuck, leaking, or the noise comes from the valve itself: Call a plumber: the shutoff valve itself is failing
Question 4: Unscrew the aerator from the spout tip and run the water. Is it quiet now?
The aerator is the screened cap at the end of the spout. Most unscrew by hand, counterclockwise as seen from below. Close the drain first.
- Yes, it is quiet without the aerator: Likely cause: a clogged or loose aerator
- No, it still makes the noise: go to question 5
Question 5: How do the handles work?
Handles that screw down several full turns are compression stems with a rubber washer. A single lever, or two handles that stop after about a quarter turn, use a cartridge or a ceramic stem.
- Two handles that turn several full turns: Likely cause: a loose or worn washer on the stem
- A single lever, or two quarter-turn handles: Likely cause: debris in or wear on the cartridge
Possible results
- Fix it yourselfLikely cause: water hammer, not the faucet
- Call a proCall a plumber: water pressure may be too high
- Call a proCall a plumber: every hot tap whistles
- Fix it yourselfLikely cause: a shutoff left partly closed
- Call a proCall a plumber: the shutoff valve itself is failing
- Fix it yourselfLikely cause: a clogged or loose aerator
- Fix it yourselfLikely cause: a loose or worn washer on the stem
- Fix it yourselfLikely cause: debris in or wear on the cartridge
Need the words for the phone call? Build a what-to-tell-the-plumber checklist, or read when to call a plumber.