You can fix this
Likely cause: a clogged or loose condensate drain
A high-efficiency furnace makes water while it heats. When its drain line clogs, kinks or slips loose, that water lands on the floor.
Why this happens
Trane explains that a 90% or higher AFUE furnace has a secondary heat exchanger that pulls extra heat from the exhaust, turning water vapor into liquid that leaves through a condensate drain line. Bryant says dirt, debris or algae in that drain makes the water back up and spill. Lennox adds that the line may simply have come loose. A common mistake is swapping the filter and calling it fixed: Bryant says a new filter will not correct a blocked condensate drain.
How to fix it
- Set the thermostat to Off and mop or wet-vac the water from a dry spot. Trane says standing water raises the risk of mold.
- Follow the drain tubing from the furnace to the floor drain or pump. Look for a kink, a sag holding water, or an end that has slipped out of the floor drain.
- Straighten a kink and set a loose end back into the floor drain.
- For a clog, first switch off the furnace power switch while standing on a dry floor. Carrier says to turn off the power before you clean the drain line. Lennox suggests flushing with equal parts white vinegar and hot water, repeating if needed. Do this only where your furnace's own owner's manual shows a drain cleanout outside the cabinet. Lennox notes the clog can also sit in the condensate trap. The trap is attached to the furnace and is a job for a technician, so if there's no such opening, leave it.
- Don't take apart the trap or any fitting attached to the furnace.
- Set the heat back on and check the floor after a full heating cycle. Carrier says water dripping while the furnace runs is often a sign condensate isn't draining correctly.
When to stop. If water reaches wiring, an outlet or the inside of the furnace, stay out of the water, keep the heat off and call an HVAC technician. Lennox warns a leaking furnace carries a risk of shock. Do the same if water still pools after a full heating cycle or comes from a fitting on the furnace. Bryant advises against opening the cabinet.
If this does not fix it, tell the HVAC technician
- That the furnace has white PVC pipes and leaks while the heat runs.
- What you found on the drain tubing: a kink, a loose end, or a clog, and whether flushing helped.
- Whether the leak started soon after a new install or a service call. Bryant says that often means a drainage or connection issue.
- The brand and model from the furnace's data plate.
Build the full list: what to tell the HVAC technician.
Not quite what you are seeing? Other results in this troubleshooter: Gas smell or CO alarm: get outside now; Water near wiring or a leak you can't place: stop and call; The leak isn't the furnace: call a plumber; the furnace humidifier; the condensate pump; Frozen drain or a dripping vent pipe: call an HVAC technician; Water at a standard furnace: call an HVAC technician.
Start this troubleshooter over
FourHome is our sister brand. Browse all FourHome replacement faucet and shower parts on the FourHome Amazon store. We earn from purchases made through this link.