Vent, Valve & Volt
Outdoor faucet leaking, dripping or frozen

You can fix this

Likely cause: a loose or worn packing

A steady leak from behind the handle while the water runs is the stem packing. Snugging the packing nut often stops it; if not, the packing gets replaced.

Why this happens

The packing is a rubber seal that a nut squeezes around the stem behind the handle. Prier calls a handle leak a common maintenance item on any packed valve of any brand, and says tightening the nut forces the packing tighter around the stem. Woodford's sheet for its Model 14 and 17 faucets says the packing nut occasionally needs tightening, and that persistent leaks need new packing.

How to fix it

  1. Check your faucet's instruction sheet first. Legend's sheet for its T-550 sillcock says not to disassemble or service it at all, and to call a licensed contractor if it fails, and says a continuous stream from behind the handle means failed stem packing or vent. If you have a T-550, or your sheet says the same, leave the nut alone and call a licensed plumber.
  2. Check for a Woodford Model 20, 25 or 27 before you put a wrench on anything. On those, Woodford says the nut behind the handle is a head nut with left-hand threads that comes off clockwise, and that water from the drain holes behind the handle when the faucet is full on means a damaged drain valve, not packing. Do not snug that nut: shut off the water and use the RK-25 repair kit. On other faucets, snug the packing nut behind the handle with a wrench, a little at a time, until the leak stops. Woodford says to turn it clockwise on its Model 14 and 17 faucets. Family Handyman says some faucets have reversed threads that tighten counterclockwise, so test the direction gently, and if the leak gets worse, stop and turn it back.
  3. If snugging does not stop it, shut off the water to the faucet at its inside valve (the Saving Water Partnership says it is usually in the basement or crawl space) or at the main. Turn the valve by hand only. Open the outdoor faucet to drain it.
  4. Take out the handle screw and handle, then back off the packing nut.
  5. Replace the packing with the one from a repair kit that matches your faucet's brand, as Family Handyman advises. Woodford's sheet for its Model 20, 25 and 27 faucets says not to lubricate any part of the repair kit or faucet, because it can make the rubber wear out faster.
  6. Reassemble, turn the inside valve back on and test with the water running.

When to stop. Stop cranking once the nut is snug; Family Handyman warns not to tighten it hard. If new packing does not stop the leak, Family Handyman says the stem may be leaking and the faucet should be replaced, which is a job for a licensed plumber. If water appears inside the wall instead of at the handle, the pipe behind it has split: turn the faucet off and call a plumber. If the inside valve will not close by hand, do not force it.

If this does not fix it, tell the plumber

  • The faucet leaks from behind the handle whenever the water runs.
  • Whether you tightened the packing nut and replaced the packing.
  • The brand and whether it is a frost-free faucet.

Build the full list: what to tell the plumber.

Not quite what you are seeing? Other results in this troubleshooter: Split pipe inside the wall: call a plumber; a frozen outdoor faucet; a fouled or cracked vacuum breaker; a worn seat washer; Worn seat or broken stem: call a plumber; Probably normal: a short spurt or drip.

Start this troubleshooter over

FourHome is our sister brand. Browse all FourHome replacement faucet and shower parts on the FourHome Amazon store. We earn from purchases made through this link.